Description

Why Do You Need the Glow30 Side Lighting? Most grow lights are mounted on top of grow tents, but light struggles to penetrate deep into the lower canopy. This means lower buds and branches receive less light, resulting in slower growth, smaller yields, and lower potency compared to the top. Without proper lighting, you’re not maximizing your plant’s full potential.

The Spider Farmer Glow30 solves this problem (side lighting, under lighting, supplemental lighting)! The high-density LED arrangement provides targeted side lighting, ensuring lower buds get the extra light needed for bigger, denser, and healthier growth. The flexible installation lets you mount it on the grow tent sidewalls or place it anywhere for optimized light distribution.

Plus, it produces low heat and uses only 32W of power! Even with 4 hours of daily use over 21 days, your electricity cost will be just a few dollars. With enhanced light coverage and higher yields, the Glow30 is the ideal upgrade for your grow setup.

Upgraded high-density LED chip arrangement for even light distribution, enhancing plant growth.

Four 13″LED bars designed for inter-canopy or supplemental lighting to boost plant yields.

Provides expanded light coverage to areas your primary grow lights have trouble reaching.

360 degrees rotating spacers on the clips allow you to adjust the light direction.

Length of wires at both ends of a single light bar: 70cm/25.56″

Length of wires at both ends of a single light bar: Single Bar Size: 13.54″ x 1.77″ x 1.46″/34.4 x 4.5 x 3.7cm

Specifications

Product Identification

Product Name: Glow30

Spectrum: 650-665nm, 3000-3500k, 5000-5500k

Diode Amount: 180 pieces(45*4)

Product Dimensions

Single Bar Size: 13.54 * 1.77 * 1.46 IN / 34.4 * 4.5 * 3.7 CM

Net Weight: 1.7 lb / 0.77 KG

Single Bar Wattage: 8W plus or minus 5%

Input Voltage: AC 100-277V

Frequency: 50/60Hz

AMP: 0.3505A/embed/9easog-miCo” title=”YouTube video player” frameborder=”0″ allow=”accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture” allowfullscreen>